V2000-c Rfid Access Control User | Manual Free

Always consult the physical manual included in your box, as manufacturer firmware updates may slightly change the command sequences.

Improper wiring is the most common cause of access control failure. The V2000-C is relatively simple to wire, but attention must be paid to the specific terminal labels. V2000-c Rfid Access Control User Manual

Always use a dedicated 12V DC power supply. If you are using an electromagnetic lock (Maglock), connect it to the NC and COM terminals. 3. Programming Basics To make any changes, you must first enter Programming Mode . Enter Programming Mode: Press * + Master Code + # Default Master Code is usually 123456 or 999999 . Exit Programming Mode: Press * 4. User Management Adding a User (Card or PIN) Enter Programming Mode. Press 1 . Swipe the RFID Card OR enter a 4-digit PIN followed by # . Press * to exit. Deleting a User Enter Programming Mode. Press 2 . Always consult the physical manual included in your