Cat-3.5h.gcode

Typically 0.2 mm , though the slow speed results in much higher detail than standard 0.2 mm prints.

To save time, the cat does not need to be solid. The file usually employs Lightning infill, which prints support structures only where the top layers need bridging. This reduces filament usage by nearly 60% compared to a 20% grid infill, shaving off roughly 1 hour of print time. cat-3.5h.gcode

Because this is a pre-sliced file, you cannot adjust the settings on your computer (the G-code is locked). You must adjust your printer to match the file. Typically 0