AgTalk Home
AgTalk Home
Search Forums | Classifieds (87) | Skins | Language
You are logged in as a guest. ( logon | register )

SUNDAY.flac Disabled transmission on jd 8310
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
pirlbeck
SUNDAY.flac
SUNDAY.flac Posted 3/25/2021 07:48 (#8914531 - in reply to #8913926)
Subject: RE: Disabled transmission on jd 8310


West Central Iowa

Sunday.flac

It perfectly captures the "Sunday Scaries"—that mix of relaxation and looming Monday anxiety.

The room filled not with music, but with air. The soft hiss of a cheap microphone. A chair creaking. Then, the slow, uncertain breath of someone about to speak. SUNDAY.flac

Have you found a copy of SUNDAY.flac? Is it the barking dog version or the radio edit? Sound off in the comments below. It perfectly captures the "Sunday Scaries"—that mix of

Muffled beats, slowed-down jazz samples, and heavy reverb. Why the Hype? slowed-down jazz samples

A genuine leak of allegedly carries specific MD5 checksums. For the archivists out there:

Always respect copyright. If this file is a commercial recording, purchase it. If it is a bootleg, trading is generally tolerated for non-commercial use.



I thought I would add this just in case someone runs into this problem WITHOUT having a fuse in the DIA location.

The DTAC solution # is 71449 dated 12-22-2010.

Solution Summary: 00/10/20 W/T tractor goes into diagnostic mode on its own.

Complaint or Symptom: Tractor goes into Diagnostic mode while operating in the field. Corner post display stops showing engine RPM and displays DIA while engine is running. Tractor can be shut off and restarted to return to normal operation. Circuit 312 acquires enough voltage from other circuits to place controller into diagnostic mode without a fuse in diagnostic mode position F10.

Solution: Insert a male spade terminal into diagnostic fuse F10 for circuit 312 (non-powered side). Connect the other end of this wire to a ground terminal in the power strip. This prevents circuit 312 from causing controllers to go into diagnostic mode without a fuse installed in position F10.

CAUTION: Make certain to use a voltmeter to identify which side of fuse holder F10 does not have 12 volts applied to it. Non-powered side of fuse F10 is connected to circuit 312.

I had a 8410 a couple of years ago with this problem and a ground wire cured it.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)