Disclaimer: This article is for informational purposes. Always disconnect power before servicing any drill press. Strands and S68 are trademarks of their original holders, who are not affiliated with this guide.
| Interval | Action | | :--- | :--- | | | Wipe column with light oil (ISO 32). Clean chips from table T-slots. | | Monthly | Remove quill. Grease spline shaft with lithium grease (2 pumps). | | 6 Months | Check V-belt for wear. Lubricate motor bearings (if serviceable). | | Yearly | Replace felt wick in spindle pulley (Part #S68-14). Check runout (<0.08 mm). | Strands S68 Drill Press Manual
– Engineering precision since 1946
The drill head is often adjustable 360° around the column and can be raised or lowered to accommodate large workpieces. Tool Ejection: Often includes a quick tool ejector for efficient bit changes. Gear Selection: Disclaimer: This article is for informational purposes
A crucial table. The S68 uses a dial-operated Reeves drive. The manual provides the RPM range (e.g., 200 RPM to 3,600 RPM) and corresponding belt settings for high/low range. Operating the S68 outside its recommended speed for a given drill bit size (e.g., a 1-inch bit at 3,000 RPM) is dangerous and outlined in the safety section. | Interval | Action | | :--- |