Fnirsi-1013d Firmware Update |verified| < TRENDING × Tricks >

Updating the firmware on your FNIRSI-1013D digital oscilloscope can improve system stability, fix known bugs (such as the 100mV switch issue), and in some cases, provide access to more accurate measurement displays.

| ST-Link V2 Pin | Fnirsi-1013D SWD Header | | :--- | :--- | | 3.3V (or 5V - check your ST-Link) | VCC (3.3V) | | SWDIO | SWDIO (Data) | | SWCLK | SWCLK (Clock) | | GND | GND (Ground) | Fnirsi-1013d Firmware Update

| Issue | Likely cause | Solution | |-------|--------------|----------| | “File not found” | Wrong filename | Rename to exact required name (case-sensitive) | | Update hangs at 0% | USB drive incompatible | Try a different brand (older, smaller capacity) | | Device won’t power on after update | Wrong HW version | Contact Fnirsi for recovery .bin & JTAG method | | Touchscreen unresponsive after update | Calibration lost | Perform touch calibration via physical buttons | Look at the main PCB

The latest community files are hosted on GitHub, specifically the Peco FNIRSI 1013D Firmware repository and the Atlan4 Fnirsi1013D repository . and in some cases

Open the back case (four Phillips screws under the rubber feet). Look at the main PCB.

: In the oscilloscope’s "About" or "System" menu, ensure the device is recognized. On the PC software, click "Connect," then select "Firmware Upgrade" followed by "BOOT/Restart" .